|
What am I doing wrong? grrrrrrr
Hello All...
So my team(2648) just bought a new black Jaguar, and the required serial to rj12 connector.
I hooked it up to my computer, and ran the BDC-COMM program, it says "Status: Connected"
I downloaded the firmware, qs-bdc25.bin and it seemed successfull.
then I preceded to try to set the motor voltage, and the display at the bottom of the GUI says Vout 11.95. But when i connect a meter to the terminals, i get az reading of 0. Also after connecting a motor, changing the voltage again, the motor does not move.
any ideas?
Did i do something wrong.
Is tehre any documentation otner than that of whats on the luminaryMicro site?
Thanks,
__________________
Blake
Electrical, Programming and Design
Mass FRC Team 4909: The Bionics
Maine FRC Team 5122: The RobOTies (2014-2015)
Maine FRC Team 2648: Infinite Loop (2008-2011)
|