Teleop to No Comms? - Chief Delphi

08-10-2010, 17:03

nighterfighter nighterfighter is offline

1771 Alum, 1771 Mentor

AKA: Matt B

FRC #1771 (1771)

Team Role: Mentor

Join Date: Sep 2009

Rookie Year: 2007

Location: Suwanee/Kennesaw, GA

Posts: 835

Teleop to No Comms?

Hi-

I am at a loss here.

I was able to download and run C++ code just fine on our robot, but when I went to make a small change, something happened...

The Driver Station connects (tethered) to the cRIO, and the "Teleoperated Disabled" message appears, but less than 2 seconds later, it loses communications, and then cycles through this process.

We have tried reformatting the cRIO, and it did not help.

Ideas?

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Camera + DS Comms	Sauce	Programming	6	21-01-2010 20:11
No comms because of router reset?	vivek16	FRC Control System	3	25-08-2009 21:06
No Comms Issue....	JoeyTNT280	FRC Control System	9	11-06-2009 20:32
Teleop Lag	Xavier Brandall	Programming	14	17-03-2009 18:21

All times are GMT -5. The time now is 05:43.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.