how to setup a can crio wred adapter???

PeterH · #1 08-12-2010, 14:47

Connor M · #2 08-12-2010, 14:47

A very good question

PeterH · #3 08-12-2010, 14:50

Or where can we find the instructions?
We trid looking on First but were unable to find any.

EricH · #4 08-12-2010, 14:54

First, what is a "wred adapter"?

Next, I assume that you want to use CAN to control Jaguars.

Using clear language can help a lot...

Now, there are 2 ways to run CAN from the cRIO to the Jaguars. You could use a black Jaguar or a 2Can unit. I don't know details of setting up either one.

PeterH · #5 08-12-2010, 14:59

Sorry, I meant to say "Wired"

Ether · #6 08-12-2010, 15:19

Quote:

Originally Posted by PeterH

Sorry, I meant to say "Wired"

Here's a thread that might be of interest.

Mr. Lim · #7 10-12-2010, 10:36

Gents,

Whoever posted this question needs to come see me at the next robotics meeting.

We apparently need to do a quick review of how to form complete sentences.

This will be followed by a refresher on manipulating your opposable thumbs.

Frankly, the original post is embarrassing to the team and myself.

-Mr. Lim...

Mr. Lim · #8 10-12-2010, 10:44

The setup documents can be found here:

http://www.luminarymicro.com/jaguar

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
CAN setup troubles	Radical Pi	CAN	2	06-02-2010 09:22
How can you add more rom space to the cRIO?	Comatose	FRC Control System	8	05-02-2009 21:16
Team 40 cRio Setup Workshop Sunday 1/11/09	Kingofl337	General Forum	0	07-01-2009 16:18
Can somebody teach me project setup in MpLab?	brennerator	Programming	1	09-01-2007 08:20