|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
<G11> CENTER LINE
I'm having trouble finding where in the rules CENTER LINE is defined?
|
|
#2
|
|||
|
|||
|
Re: <G11> CENTER LINE
It is shown in the unofficial illustration in section 2.2.2 FIELD Markings
It should be in drawing FE-00034 (Page 5 of link below), but it is not. Post to Q&A so they can include in Team Update #4. http://usfirst.org/uploadedFiles/Rob...%20Marking.pdf |
|
#3
|
|||
|
|||
|
Re: <G11> CENTER LINE
While you're posting to Q&A - remind them they are missing a vertical dimension on the ends of the Y portion of the tape. See attached image.
They could alternately specify the angle of the Y. |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|