|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
No FIRST library in LABVIEW!
After installing the updates for labview i noticed there was not a frc library in labview. How do i get it back??
|
|
#2
|
|||
|
|||
|
Re: No FIRST library in LABVIEW!
You need to install the 2011 LabVIEW Update. Bookmark this page: http://www.usfirst.org/frc/kitofparts
Go to the link for "Getting Started with the 2011 FRC Control System." It has links to all the updates you need for LabVIEW. While you're on the KOP site, make sure you get all of the updates downloaded for your driver stations as well. When you get to competition, if your cRIO, LabVIEW, and Driver Station all aren't on the latest rev, you won't pass inspection. Good Luck, Sean Spooner Mentor, Team 126 GaelForce |
|
#3
|
|||||
|
|||||
|
Re: No FIRST library in LABVIEW!
Bookmark this page too: Software Updates
There will be future updates posted there over the next couple of months. Check back every so often to see what patches have been issued. |
|
#4
|
|||
|
|||
|
Re: No FIRST library in LABVIEW!
Put simply, installing LabVIEW does not give you special FRC libraries. It only gives you standard libraries. Others must be found elsewhere, like in the kit of parts.
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|