|
|
|
 the Robotics team isn't just a club, it's a family. - 1086Programmer [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| the Robotics team isn't just a club, it's a family. - 1086Programmer [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Wiring LEDs using I/O module at driver station
I need to look into using the I/O module for wiring LED feed back at driver station. My team is presently looking for the module (last years kit?), hopefully there will be paperwork with it. In the meantime, I would like to look into how to do this. I Found ‘how to configure I/O module’ but no data sheet. Does anyone have the data sheet? Do you know if we have to use resistors to pull up/down current for LEDs? How much current sources/sinks the
digital I/O? thanx Mark 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode