|
|
|
 I design gears and gear boxes for a living. I am HAPPY to write a check and have a solution in mailed to me. - Joe Johnson [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| I design gears and gear boxes for a living. I am HAPPY to write a check and have a solution in mailed to me. - Joe Johnson [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Invert Motor Not Honored
It could simply be me, but..
When using OPEN 4 Motor Can Jaguar, it appears that the Boolean to Invert either the right or left motors is not being honored correctly. I push the joystick forward and it runs backwards for both left and right. I've tried a number of permutations and the results are always the same. I've checked my electrical and can wiring. I do have both FRONT and REAR motors on each side connected their appropriate Boolean. Has any one else experienced this? I'm stumped. 
|
|
#2
18-02-2011, 22:23
|
||||
|
||||
|
Re: Invert Motor Not Honored
Well I am at a loss to explain it... However, it appears to working normally now.
There have been too many changes since I experienced this Labview Update 3.2, CRIO Image V28. A complete new project. Apparently, it's a red herring as I'm at a loss.
|
|
#3
18-02-2011, 23:05
|
||||
|
||||
|
Re: Invert Motor Not Honored
it's hard telling really. We've been having weird issues that just don't make sense. It's just the joys of programming I guess.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
