|
|
|
 I don't care if your robot could eat ours for breakfast - PayneTrain [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I don't care if your robot could eat ours for breakfast - PayneTrain [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
No Robot Code :-(
eventhough the code is running in LabView on my PC, the robot is showing no robot code. The code deploys successfully but dosen't show anything on the driverstation. But the camera connected straight to the radio respondds well on the Dashboard.
Reformatting the cRio did not help. Any Suggesstions GUYS . ANYTHING? lol thanks   
|
|
#2
14-02-2011, 13:30
|
||||
|
||||
|
Re: No Robot Code :-(
Are you sure you have your C-rio configured correctly. Also make sure that your project's ip address is correct. Thats all I can think of that would cause it to show no code.
|
|
#3
14-02-2011, 13:41
|
|||
|
|||
|
Re: No Robot Code :-(
Yes Sir. i made sure everything is correct. I'm updating labview again just in case.
Thanks though :-)
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Hybrid Mode
