|
|
|
 Last year we saved a ton of money by using a good bit of square tubing for the frame of our robot, square tubing is a lot cheaper then C channel. We get to use so much raw material that the cost should go down in certain places. - Derrick Maust [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||||
|
|||||
|
CAD File for Line Following Sensors?
Does anybody know if there's a CAD file of the line following sensors this year? If so, attaching the file would be appreciated.
Thanks, -Duke P.S. Preferred File Type: Inventor |
|
#2
16-02-2011, 23:20
|
|||
|
|||
|
Re: CAD File for Line Following Sensors?
Its essentially just a rectangle with cylinder attached to it right? Seems like a good opportunity to practice your modeling/reverse engineering skills. It shouldn't be too difficult to measure and draw.
|
|
#3
17-02-2011, 15:40
|
|||||
|
|||||
|
Re: CAD File for Line Following Sensors?
Yes, i can easily make it, but i like the files given on sites like firstcadlibrary.com that have all the colors and the labeling all nice and neat. Making the actual shape is not a problem at all for me.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Hybrid Mode
