Unable to Recover cRio after failed firmware update

[Kingofl337]

So, after competing all day with v27 yesterday, according to team update 12 we needed v28 for the cRio Image. So when we went to update the cRio it failed to restart after setting the the ip address for update. After restarting it manually it came up with 0.0.0.0.

So, we tried again and it said it couldn't update the cRIO with ip address 0.0.0.0. Set the cRio to safe mode and tried again and told it to force format the cRio. That didn't work either, when it says "Setting the IP Address Safe Mode" the cRio reboots. But then it says its rebooting again and the cRio never does.

Here are the logs from the serial port. The first is normal boot and the second is safemode.

I'd like to point out that personally I have updated the image on over 50 cRio's in the past two years and I've never not been able to recover one that is stuck in this mode, until today. I also went through the FRC manual to recover it.

Joe H. HELP!!! Please! If there is someone from NI I can call today that can help, PM me I would be greatly appreciative.

-Adam