|
|
|
 They had me at "chocolate-covered bacon".... - Foster [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| They had me at "chocolate-covered bacon".... - Foster [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
How to use driver station inputs
i have looked many places for an answer to this, and I knew how to do this 6 weeks ago, but now I can't figure out how to turn a digital input on or off on the driver's station. We're calling it correctly, with ds->GetDigitalIn(1), for instance, but on the screen itself, I'm not sure which button this is, or how to turn it on or off.
thanks! 
|
|
#2
04-04-2011, 20:42
|
||||
|
||||
|
Re: How to use driver station inputs
Go over to the I/O tab and click on one of the buttons. You may have to click on "configure" and select compatibility IO.
Or, you could attach the cypress I/O board that came in the KOP and wire in some switches.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
