|
DLINK Not Communicating with Bridge
Hello all,
I have my DLINK attached to my robot and the wireless bridge attached to the classmate. I have reset the settings on the Dlink multiple times and have followed the instructions to the letter for configuring it for use.
On the wireless bridge, I have reset it to factory standards and then followed the instructions from the 2010 book for configuring it for use.
The IPs of the system are:
Classmate: 10.8.88.51
Bridge: 10.8.88.4
Dlink: 10.8.88.1
Both the classmate and the DLink have a default gateway of 10.8.88.4
I have turned off all the wireless protection on the DLink, but I cannot connect the Dlink and the Bridge while in wireless. When ethernet connected, they communicate fine and I can ping and run the robot from the DS. When I disconnect, I get nothing.
Can anyone please help me?
__________________
Morton
Team 888
"Any sufficiently advanced technology is indistinguishable from magic." - Clarke
|
"We're too close for missiles, switching to Poof balls!"
"Just one more day on the driving code, then I'll switch to autonomous." - Rick TYler [more] 
Threaded Mode