|
|
|
 FIRST is not all about the robot, it's about the experience. Don't sour yours by whining about it later. - StephLee [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| FIRST is not all about the robot, it's about the experience. Don't sour yours by whining about it later. - StephLee [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
pic: (First) Sheet Metal Design- Swerve
|
|
#2
13-09-2011, 20:38
|
|||
|
|||
|
Re: pic: (First) Sheet Metal Design- Swerve
Nice rendering. Those chamfered corners may be a pain to put bumpers around.
|
|
#3
13-09-2011, 21:00
|
||||
|
||||
|
Re: pic: (First) Sheet Metal Design- Swerve
You may want to take a look at something like this http://www.chiefdelphi.com/forums/sh...rve+staplemonx
|
|
#4
13-09-2011, 21:29
|
|||
|
|||
|
Re: pic: (First) Sheet Metal Design- Swerve
Quote:
Your current sheetmetal enclosure in your current design can be replaced with more tubing. You'd probably be using the same amount of material, and right now it doesn't seem like the actual sheetmetal parts you have are serving much of a purpose. A chassis such as the one staplemonx posted is making use of the sheetmetal in a structural manner, not as an enclosure such as your design.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Hybrid Mode
