Errors When Deploying to Simulator

Collaboration works. DO IT. - Travis Hoffman [more]

		Chief Delphi > Technical > Programming > NI LabVIEW
Errors When Deploying to Simulator

Thread Tools

Rate Thread

Display Modes

21-01-2014, 17:46

DarthMaulCIS DarthMaulCIS is offline

Registered User

FRC #4607

Join Date: Jan 2014

Location: Becker, Minnesota

Posts: 24

DarthMaulCIS is an unknown quantity at this point

Errors When Deploying to Simulator

"Block Diagram Errors
Wire connected to an undirected tunnel.
This wire connects one or more data sinks but has no source."
This shows up when I try to deploy my code to the simulator. I think it is because I have code in my begin that I don't have corresponding pieces to in teleop, but I'm not sure. I can email you guys our code so far if you want to help.

Attached Thumbnails

Click image for larger version

Name: problem.png
Views: 39
Size: 123.2 KB
ID: 15897

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 02:10.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.