|
|
|
 As an adult who has spent years working with youth in Boy Scouts and FIRST, and on behalf of all other adults at the event: deodorant. - Rick TYler [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| As an adult who has spent years working with youth in Boy Scouts and FIRST, and on behalf of all other adults at the event: deodorant. - Rick TYler [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Problems reimaging cRIO
I've made it up to the point where I need to reimage the cRIO. I have the updated code on my laptop. I have the orange cross over cable directly from my laptop to the cRIO port 1. (I've also tried every other possible connection there is and no difference). Static IP set to 10.14.44.6 mask 255.0.0.0
The FRC cRIO Imaging Tool opens and sees the cRIO as 10.14.44.2 When the imaging tool tryes to connect it give me the error "The specified IP address is unreachable. Ensure that the IP address is on the correct subnet." I've disbled the PC firewall and disconnected from the wireless network. I have been able to connect a few times after reconfiguring/reseting. Don't know why. The reimaging gets started but then I get an undexpected error 60. The next time I try, I'm back to the first problem. Any advice? |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problems undeploying a program from the cRIO | ellisk | Programming | 2 | 29-12-2008 16:21 |
| cRIO interrupted during reimaging | rsisk | FRC Control System | 23 | 21-12-2008 22:41 |
| HELP reimaging | RMS11 | Control System | 4 | 17-12-2008 21:21 |
Threaded Mode