|
|
|
 I am sorry if something was missed at your regional, it will be checked at this event. - Al Skierkiewicz [more] |
 |
|
|||||||
|
||||||||
This is about half of the sheet metal thats supposed to go on our robot
Discussion
view entire thread
04-02-2007 20:35
rohit
Re: pic: Ramp
I forgot to make it say "Teaser" on the title.. But this is half of the sheetmetal thats supposed to go on our robot
How does it look?
05-02-2007 07:09
tdlrali
Re: pic: Ramp
I fear that that ramp has not a lot of friction. You should sandblast the surface, or it'll be hard for robots to climb up your ramp (what angle is it at?)
05-02-2007 08:52
MattLi
Re: pic: Ramp
WOW, half the sheet metel? I work with weight calculation and planning on my team and may I just ask one question: How heavy? It seems to weigh a lot.
05-02-2007 16:01
Snowman33
Re: pic: Ramp
Total, the pieces are from 2.5 4' x 8' .032 sheets of aluminum. me and another kid and a mentor punched and flanged 1,056 holes by hand 1 x 1.
And we still have to make spares.
05-02-2007 19:17
rohit
Re: pic: Ramp
Yup.. the dimples go down for the robot to go on the ramp. I will upload a pic of the unfolded ramps (on Inventor) tomorrow so you understand how the ramp will work
The holes are for taking the weight of the robot down & to make the ramp stronger. There are about 34 of those pieces. And we dont know what will be in the middle ramp.
Basically, the piece in the middle is the robot. The pieces on the two sides are the platforms. And, more pieces will fold down for the ramp. So, it will be gigantic once it unfolds. So, there will be 3 platforms for the robot to stand on & 3 ramps for the robot to use to get on the platforms 
You'll see what I mean once I upload the new pic.
view entire thread
Tags
loading ...