02-17-2010 02:20 PM

JamesCH95

Re: pic: Integrated, easy to use chain tensioners

I like the use of turnbuckles.

My team has had good luck for years just dimensioning the spacing properly and not having any adjustment. =shrug=

02-17-2010 03:35 PM

J_Beth

Re: pic: Integrated, easy to use chain tensioners

I like the idea. the only problem that i could see is it bending because it is only attached in two corners. But if that is not a problem then i like it.

02-17-2010 03:38 PM

BEEKMAN

Re: pic: Integrated, easy to use chain tensioners

i like it! very original

02-17-2010 04:02 PM

rsisk

Re: pic: Integrated, easy to use chain tensioners

That is a sweet looking idea.

In the picture, won't the motor hit the metal plate below it as you tighten the turnbuckle?

02-17-2010 05:33 PM

Jon Stratis

Re: pic: Integrated, easy to use chain tensioners

We aren't worried too much about anything bending - it's all strong enough to handle the stress that will be placed on it.

As pointed out... The bottom pan does restrict the rotation a bit... That's one of the challenges of going over the bump! We think we still have enough adjustment for our needs - if we need more, somethig is seriously wrong.

02-17-2010 09:36 PM

daltore

Re: pic: Integrated, easy to use chain tensioners

We tried using a turnbuckle for this purpose on our arm motor in 2008, and every time we got any bit of tension on it, the loop side of the turnbuckle bent open. I hope it works for you, but do monitor the stresses on the turnbuckle hooks.

02-17-2010 10:02 PM

DonRotolo

Re: pic: Integrated, easy to use chain tensioners

Now, I'm an electrical guy, but I'd be worried about the torque that the upper nut and screw will experience, which comes from the fact that the chain is pulling on that gearbox a few inches away from the gearbox's center. Seems to me you're going to bend that bolt right quick. It won't come out easily when it does.

02-18-2010 01:22 PM

Jon Stratis

Re: pic: Integrated, easy to use chain tensioners

daltore - The gear box has been fully tensioned for over a week now, and we haven't seen any deformation of parts. How was yours used - in tension or in compression? It's hard to explain, but the turnbuckle here pushes out against the two bolts, so most of the force is directed along its axis, instead of on the loops. If we ran it the other way (from a different corner, for example) where it was pulling on the gear box to create tension, i would expect we might see the loops open up.

Don - It's hard to see in the picture, but that upper corner is supported on both sides by some pretty thick aluminum, and those plates are part of a bracket that attaches to the frame very securely. We aren't worried at all about the bolt sheering, and if it does happen to bend a little... we have saws and drills that can get it out if we have to use the box in another robot

02-21-2010 10:37 PM

JamesCH95

Re: pic: Integrated, easy to use chain tensioners

Quote:

Originally Posted by daltore We tried using a turnbuckle for this purpose on our arm motor in 2008, and every time we got any bit of tension on it, the loop side of the turnbuckle bent open. I hope it works for you, but do monitor the stresses on the turnbuckle hooks.