03-01-2013 22:15

RyanCahoon

Re: pic: 8WD Gearbox Module

A few questions (also for the related chassis render):

Has your team built this design? How well did it run?

How were the outer wheels supported? Was there any additional support for the middle pairs of wheels or just the transmission? It seems to me like you would have any issues with suspending that much load from a few pairs of standoffs, and some of the load would be supported by the axles and bearings, which would reduce the efficiency.

What is the weight of this design versus that of the same design using a COTS shifting gearbox and belts? How thick did you make the gearbox plates?

Thanks,

04-01-2013 10:08

Alan Anderson

Re: pic: 8WD Gearbox Module

Two motors for two wheels implies eight motors for eight wheels. That's a lot of drive motors.

04-01-2013 10:13

Akash Rastogi

Re: pic: 8WD Gearbox Module

Quote:

Originally Posted by Alan Anderson Two motors for two wheels implies eight motors for eight wheels. That's a lot of drive motors.

06-01-2013 11:35

AaronSonn

Re: pic: 8WD Gearbox Module

The design was never built. The outside wheels haven't had a support designed yet and the frame is a very rough design that would have additional reinforcements depending on the special functions. The gearboxes will be supported by bolts both on the back and on the front side and those spacers are only used to space the plates apart. The gearbox assembly weighs 12 pounds with everything in the picture. The benefit of this gearbox/drive train is that the interior wheels are gear driven so there is no issue of chain or belt slippage or stretching. The gearbox plates are 3/16 in the design but i believe we are using .19" because it is much cheaper.