I have a question about the 2005 Interface According to the Documentation you can access channel 01 on it by turning 1 (don’t care posstition) 2 (on) 3 (off) 4 (on). And Pins 8 & 12 need to be shorted / jumpered. I have done all this but I keep getting Channel 40. Note: This Channel is only accessible on the 2005 OI - or at least thats what the documentation says.
For A Disable Switch - Not an Autonomous Switch Pins 6 and 8 need to be hooked up to a switch of any kind correct? Does Pin 6 Need to Short / Jumper to Pin 8?