We have been getting a lot of requests for videos, and more pictures. The main problem was that I was putting them up, on our old thread. The problem with that is that our other thread is so deep in Delphi, that I am going to post a new thread that way people can find a link to the videos we have, so here they are:
You can see the evolution of the robot through these videos. First just a chassis, then we have Mach One of the tube, (Videos two and three), and then Mach Two, (Videos four and five), which is the current setup that we are using.
Thanks to all of the people that have given such awesome feedback and comments. Good Luck to all teams.
These are older videos befor we changed the bursh motor to a sim motor.
It now spins at a much faster pace shooting the balls faster.
Also we are currently attatching an extention piece for the end that has one bursh on it with it’s own motor so it will be the ‘power’ at the end of the line ;]
Yes sadly we had to change it to 2WD from the rear cus the motors were hitting the cage. however this became an advantage to us allowing us to put more power to the brushes.
Were going to Micron today where they have graciously set up a practive feild for us to practice on :] so we hope to have more pics and vidoes up soon.
