http://i.imgur.com/RXarGK0.jpg
Anyone else see this? It’s a metallic layer and I’m afraid of it shorting our electronics. I haven’t heard of this and I’m sure I would’ve seen it on here.
Wouldn’t sweat it to much, but did you get the motor hot or anything?
No, it ran once for a few seconds. It just started peeling and I flaked it off very easily. It looks like all the loose stuff is gone now.
Hard to tell in pic, but looks like it’s just the plating from the band around motor. I would however take a picture showing the numbers so if any more flakes off you can show robot inspector what kind of motor it is. Better to cover your butt than not
You should report this to WCP and VEX. They need to know about it.
We had a similar case with one of our 775 pro’s. However with ours it arrived like this. There was a semi large section without coating slightly eating into where the numbers are.
mastachyra,
Shoot me an email and we’ll take care of you.
-Aren