I am using our new OM5P-AN dlink, but I can’t connect because it won’t even appear as an option to connect to. Usually if I had this problem in the past, I would reset the DLink, but there seems to be no manual reset on the new DLink. Any help appreciated!
Are you sure it is plugged into the 12V port on the voltage regulator module?
The OM5P-AN replaces the DLink for 2016 – calling it the DLink might cause some confusion.
Have you run the FRC configuration program? Until you configure the OM5P-AN it’s not set up for your team.
If it’s not from the KOP you’ll have to update the firmware to the custom FRC firmware. Check under New for 2016 in the Getting Started… documentation:
https://wpilib.screenstepslive.com/s/4485
I think this will take you directly to the right place:
Check out this link for instructions that you may find helpful. The only way to reset the new radio is to use this tool.
http://wpilib.screenstepslive.com/s/4485/m/13503/l/144986-programming-your-radio-for-home-use
-Hugh