Dual stick controlling with a 360 controller

Technical NI LabVIEW
1

Ok so first year programmer here and im looking for a way to make use of both sticks on the 360 controller. More specifically using one stick to control one set of motors and the other to control the other set. im not new to programming but i am new to LabView. excuse me if there is already another thread about this topic im not very good at searching forums.

thanks in advance guys
-Crazykid

2

Just route the wires out of the joystick to the different motors.

OneJoystickTwoMotors.png

XBoxControlMapping.jpg
XBoxControlMapping.jpg801×638 46.1 KB



OneJoystickTwoMotors.png
XBoxControlMapping.jpg
XBoxControlMapping.jpg801×638 46.1 KB

3

Thanks took me a few minutes to figure out I had referenced the drive system instead of motors so the config you gave me wasn’t working. But It works now so thanks.