Error Message-Any Ideas?

We keep getting this error message and can’t figure out what is wrong. Any ideas?

That means that LabVIEW cannot find the Target you’ve specified.
There are various possible reasons, so a few questions and requests for more debugging information.

  • Please post a screenshot of the Driver Station Diagnostic tab. That has a lot of the basic info we need to help.
  • How are you connecting to the roboRIO (USB, direct Ethernet, Ethernet through the radio, wifi to the radio?
  • What is the “Target” listed in your Project Manager (it’ll look like the attached)?


Got it! It was sending to the wrong destination

Good luck!