ERROR When trying to run test code

Technical NI LabVIEW
1

Whenever we try to run the test code that our programming teacher made for us it gives us an error saying “Connection failed. The network address might be invalid or the target is not responding.” Anyone have any experience with this issue. Sorry we are new to LabView.

2

This looks to be a networking error.

Is everything plugged in and turned on? Make sure you have connected to the robot via wireless or ethernet cable. Networking should be turned on, on the computer, and the robot’s router should be set to bridge mode.

3

  1. How are you trying to run the code? Be specific.

  2. Is the IP address associated with the Real-Time target correct? (It’s in parentheses, and should probably be in the format 10.te.am.2 where te.am is your team number split in two-digit pieces.)