Wanting to change the size of the drive base, want a little longer than square. I’ve been trying to figure out how to do this for quite a while today. Running 2015 with the KOP downloaded. I have tried both adjusting the Square assembly, as well as just trying to reassemble and changing the size of the sides. I can’t seem to get it figured out. Anyone help me a little on this? Thanks.
Let me know the exact name of the part and what you require. I will put together some instructions.
The part is probably a base solid and requires the use of the Direct edit tool. Here is the Help link.
http://help.autodesk.com/view/INVNTOR/2015/ENU/?guid=GUID-E27FC7F0-1224-491C-84C2-EC2AE77171A2
Check back with me if this does not work for you.
I think all I need is these two parts lengthened by 2 inches.
am-2952 AM14U2 Inside Sheet Square.ipt
am-2951 AM14U2 Outside Sheet.ipt
Everything else would be fine. I’ll look at the link you sent. Thanks.
Attached is one of the files. I extended it 1 inch in each direction, assuming you wanted to retain symmetry.
Review the browser to see the edits.
Note I had to extrude the semi-circles at the cut edge to make the Direct edit tool work.
am-2951 AM14U2 Outside Sheet Square_Plus2.ipt (211 KB)
am-2951 AM14U2 Outside Sheet Square_Plus2.ipt (211 KB)
Thank you!