When trying to image our limelight from 2019.1 to 2020.0, Balena Etcher will not allow us to select our limelight as the target. Instead, it displays a “Install Missing Drivers” pop-up, with the message “Would you like to download the necessary drivers from the Raspberry Pi Foundation?” We are worried that continuing with a driver installation will cause our limelight not to function. We cannot continue without installing these drivers, unless we operate using the 2019.1 image. Has anyone had experience with this issue? Any guidance is appreciated.
Go ahead and install the driver. It is needed to get the LL into imaging mode.
1 Like
This topic was automatically closed 365 days after the last reply. New replies are no longer allowed.