Looking for Labview code example for L-16 actuator

We are looking for labview code for the AndyMark L-16 actuator.

I don’t recall if this was for the exact same servo, but this should help.
The 1 and 0.15 were the limits for travel that we used. According to the manual :
To drive fully out, the position is set to 0.82.
To drive half way, the position is set to 0.5
To drive fully in, the position is set to 0.17.

servo snippet

Thank you. I will try the code in the morning.

This topic was automatically closed 365 days after the last reply. New replies are no longer allowed.