I’m a rookie programmer with team 2521, I’ve never used LabVIEW before this season, nor been on a team until this season and am pretty much self taught. I know that I wired the solenoid and pneumatics breakout correctly.
-The pneumatics breakout is in module 8 on the cRIO.
-The solenoid wire is plugged into the breakout, white to negative, red to signal.
-The wire is plugged into the solenoid, white to negative (1), red to positive (2).
My two problems are this.
- The solenoids are always open at default, is there any way to change this?
- When I use the third button on the joystick plugged into USB 1, nothing happens.
Any help would be appreciated. 