Phoenix Tuner

I am trying to get the RoboRio connected to the Phoenix Tuner. I followed the instructions that is on the “Robot Controller Install” but it doesn’t allow me to see the robot.

RoboRio is already up to date. We ran the imaging tool to update to 6.0.0f1, the newest firmware.

Second picture to show the close up message.

Have you tried to then connect to the RIO through the ip address for it? 10.TE.AM.2 ?

When I try that, it says “Could not connect”

That looks suspiciously like the Rio firmware was updated but not the image.

Make sure Rio image is v12

Oh that definitely is the case, our Rio version is at v16…

I added a more explicit warning for @Low3arth0rbit with versions.

image