Posted by Dan Grostick at 1/18/2001 10:08 AM EST
Engineer on team #267, Demolition Squad, from North Broward Prep / St. Andrews.
I’ve posted information (in the White Papers section) on the electrical wiring and programming of the pneumatics subsystem. I want to share my experiences programming the pneumatics demo board shown at the First kickoff.
Dan Grostick (267)
Posted by Vince Wilczynski at 1/20/2001 8:15 PM EST
Engineer on team #124, Whalers, from New London / Montville/ Williams School and Notheast Utilities / US Coast Guard Academy.
In Reply to: Pneumatics electrical wiring and programming
Posted by Dan Grostick on 1/18/2001 10:08 AM EST:
Thanks Dan.
One note, make sure you comment out the relay5 lines in the default program as noted below:
'relay5_fwd = p1_sw_aux1 'Port 1 Aux1 = Relay 5 Forward
'relay5_rev = p1_sw_aux2 'Port 1 Aux2 = Relay 5 Forward
/