Problem Setting Up Router

Technical Control System
1

We tried setting up the router earlier today. We went to 192.168.1.1 and entered the username and password found in the 2009 FRC Control Manual, but it didn’t accept the password.

Here’s what we did so far, in order:

  • tethered benchtop test
  • firmware update on Driver Station
  • configuration of wireless bridge

We installed the software that came with the router on the laptop we’re using. I don’t think this should cause any problems, but I don’t know for certain. What do you think is going on?

2

You shouldn’t use the code that came with the router.
You can reset the router to get back to the default state, then follow the Control System Manual chapter 5 instructions.

3

It works now. Thanks for your help!