Programming Camera that uses USB

Technical Programming
#1

Is there a way to set the camera by USB if you use a different camera? If so, how?

Thanks,

Comatose

#2

There is no USB on the cRIO

#3

There are converters from USB to Ethernet, so it would be a problem for programming. Can you set up a USB one if it was connected through a converter?

Thanks,

Comatose

#4

See <R67>

#5

If you were to have an off board computer,that did not violate any COTS rules, and you hooked said computer to the cRio using the serial port or some other port. then yes you could have a USB camera . .you would also have to program every thing to get the camera to work with the off board computer, how it would communicate, then what it would do after that. So yes it is possible.

#6

This is the way you’d have to do it, but you’re out of luck for the serial port. Digital I/O, Analog In, I2C only.