It was working on Saturday, but today it isn’t. The compressor still turns on normally, but we can’t turn on any solenoids. When using the hardware client, it shows no faults. When we mouse over the switch to turn them on/off, we see a red circle with a line through it, not letting us do it there. Anyone have any idea what could be going on?
I think the 
is because it’s receiving a signal from the roborio, which disables some functionality in the REV Hardware Client (at least it does for SparkMax’s)
As for your question of why it suddenly isnt working, I’m not sure
1 Like
Randomly started working after half an hour of trying it… would still like to know why, if anyone has ideas!
Not related to enable/disable on the roboRio, as far as we can tell.
Clarification on when it started working again. We created a new robot project with two solenoids in it, mapped to two buttons for open/close. Dead simple. Didn’t work. Then we loaded our original code back in, which wasn’t working… and then it was working.
We have honestly switched back the the PCM because of the issues with the PCH and we don’t trust it anymore
1 Like