Rev Through Bore Encoder

Hello all,

I took over FRC 4601 this season after being a student and mentor of the team since the birth of the team in 2013. This may sound like dumb question but I am not very familiar with encoders and I was wondering if the Rev Through Bore encoder was able to tell the angle of something if programmed correctly.

I.E. being able to tell the angle of a shaft that turned from a starting 0 degrees to 90 degrees.

Thank you!

Bobby Hudock
Lead Mentor
Team 4601
Canfield Circuitbirds

This topic was automatically closed 365 days after the last reply. New replies are no longer allowed.