Hello. We have connected two vortex/flex units to the bus. We have flashed them, given them addresses (35, 36). 36 keeps cycling in and out of the rev client. It is fine when off bus the only controller connected to the rev client. But as soon as we power up. 35, 36 show. Eventually 36 cycles out. Then will come back on the client… etc
Have they been replaced from the recall?
Yes. These are the replacement units.
Hello everyone. There was an address issue. Other devices, not attached, but in the code, had been given the same address. That seemed to fix it.
This topic was automatically closed 365 days after the last reply. New replies are no longer allowed.