Howdy!
Some of you may remember that I made a post a while back about this. Since then I have seen other teams use it on their own and I or my teammates have given them out to other teams in need of them at competition. It has also been put on to the AndyMark 3D printed parts page. I’m very happy with its success. I’m working on improving it. The problem that I am trying to address only occurs with a small amount of robots so I need to outsource some testing 
If you are interested in helping me out with this please post a picture of the wire that you use to power your radio in the fashion of the one that I have attached. The only prerequisite is that you must have access to a 3D printer. The thanks in advance
