Trouble deploying Program to cRIO with NetBeans

I finished programming and ready to deploy my program for a week now. However I cannot get pass where it says “Welcome To LabView Real-Time” and “FPGD software guild …”. Then Netbeans just continue to run without an end, and robot doesn’t move.

On another note, how do I get the D-Link to work as an Access Point?

Here’s an article that describes the download process and what you should see for each step. This might help figure out what’s going on in your case.

http://Wpilib.screenstepslive.com/s/3120/m/7885/l/97458

Brad