I’m looking at using SPI on the RoboRio.
I used it in 2012 on the CRIO, but as I look at the LabVIEW VI’s there are obvious changes.
Unfortunately the “Detailed Help” still refers back to all the old 2013 VIs.
Some things I’m trying to figure out:
If I select the MXP interface, which pins are used for Clk and Data.
What are the Internal interfaces listed?
I get to select the Clock Rate. What is a reasonable Max for this input.
Any other peculiarities I should know?
Is there updated docs anywhere?
Thanks in advance.