Victor and PWM Cable Problem

Technical Electrical
1

Hi.
When prototyping at tonight’s meeting, I stumbled across something:
The PWM Cables provided in the kit do not fit the slot for the PWM Cable from the Vic to the FRC. :ahh: Has anyone else had this same problem, and if you have, did you just have to notch the existing PWM connector?

Thanks in advance.

2

goto this thread
http://www.chiefdelphi.com/forums/showthread.php?t=32661

Edit:- Just trim the notches off the victor connector(not the pwm cable :stuck_out_tongue: )

3

Thanks a lot. I appreciate the quick reply.