Wiring analog breakout?

I’m not quite sure how to power the analog breakout. Thanks for the help.

You can read Chapter 3 (pg. 20 - 26) of the 2009 Control System documentation on FIRST’s website (found here)

More specifically, you can find out how to pass power to the analog breakout on page 24 of Chapter 3.

Hope this helps,

Jason Law

Ok thanks I’ll check that out.

Where does the analog breakout get plugged into the distribution block.

If you look at the power distribution diagram (found here), you will find that the analog breakout is connected to the 30A connectors on the power distribution board.

Hope this helped,

Jason Law

Ok, thanks for the help.