Wiring REV Pneumatic Hub to CTR Power Distribution board

Hi,
How would we wire the Rev Pneumatic Hub to the CTR power distribution Board?

To wire a CTR Power Distribution Panel to the rev Pneumatic hub, you’ll need 18 gauge red and black wire. Strip both ends of the wire, connect one end to the power of the rev Pneumatic hub, and the other end to the PCMc12vin terminals on the Power Distribution Panel.
Here is the picture to where to get power from on the PDP

I hope that information was helpful! Please keep me posted on the outcome. :smile:

2 Likes

This topic was automatically closed 365 days after the last reply. New replies are no longer allowed.